Skip to main content

IAR Embedded Workbench for RL78 5.20

Power Log Setup window

In this section:

What do you want to do?

YellowStripe.png

The Power Log Setup window is available from the C-SPY driver menu during a debug session.

PowerLogSetup_E2_RX_01.png

Use this window to configure the power measurement.

Note

To enable power logging, choose Enable from the context menu in the Power Log window or from the context menu in the power graph in the Timeline window.

Requirements

An E2 emulator.

Enable power log

Enables/disables power logging for the C-SPY E2 emulator driver.

Monitoring mode

Controls the collection of power data. Chose between:

  • Fill until stop—collects data as long as the application is executing. If the buffer fills up, the oldest data is cleared as new data is written.

  • Fill until full—collects data until the buffer is full, but continues executing the application.

  • Stop program when full—stops executing the application when the buffer is full.

Sampling rate

Sets the sampling rate in microseconds.

Action

Controls how power data is logged. Choose between:

  • Log all—logs all collected data.

  • Log all and halt CPU above threshold—logs all data and stops executing the application when the measured current exceeds the specified value.

  • Log all and halt CPU below threshold—logs all data and stops executing the application when the measured current falls below the specified value.