Skip to main content

IAR Debug Probes

Setup and installation

In this section:
Software

Before you can use the probe, you need to install IAR Embedded Workbench. For information, see the installation documentation.

Probe setup

I-jet probes do not require any special driver software installation. Normally, all drivers are automatically installed as part of the IAR Embedded Workbench installation.

If you need to install the USB driver manually, navigate to:

IAR Embedded Workbench for Arm:

\arm\drivers\jet\USB\64-bit (or USB3) in the installation directory

IAR Embedded Workbench for RISC-V:

\riscv\drivers\ijet\USB\64-bit (or USB3) in the installation directory

Start the dpinst.exe application. This will install the USB driver.

The USB LED will flash twice after enumerating on the USB2 ports, and three times on USB3 ports.

For information about using multiple I-jet probes on the same host computer, see the C-SPY Debugging documentation.